Description

Automatic Trolling Motor Plate by T&L Products of Michigan

This revolutionary trolling device allows you to operate your motor at a wide range of speeds from very slow to wide-open. Plus, it’s completely automatic and swings up as speed is increased, so there is absolutely no interference. Constructed of fiberglass-filled nylon, it will not rust or corrode. Works on most outboards or inboard out-drives from 50 hp on up. Mounts in just minutes. Not for use with Volvo out-drives.

Proven Performance

• Fully automatic
• No rust or corrosion
• Glass filled nylon construction

Speed Matters

• Fishermen know trolling speed is crucial
• Automatically swings up as speed is increased
• Works on most outboards and inboard drive 50 hp or higher (check size for compatibility on smaller outboards)

Easy to Install

• Mounts in minutes
• Simply drill four 1/4″ holes
• Stainless steel hardware included

Troll-A-Matic specifications:

• Bolt hole pattern (center to center): 5.063 in. on holes near the plate, 4.5 in. on the other
• Hole spacing (center to center), front to rear: 1.875 in
• Plate : 11.75 in. wide x 13.62 in. high from pivot pin
• Mounting hardware included (no instructions necessary)
• Mounts to bottom of cavitation plate
• Springs allow plate to hinge upward under full throttle
• Unit does not lock into a fully-horizontal position
• This item will not fit on Volvo outdrives because of the shape of the outdrives lower unit
• This trolling plate is not compatible with motors using a dual-propeller configuration