Description

Bullnose Rudder

Experience the best of many fishing trips with the Bullnose Rudder attached to your motor shaft – control of steering, easy turning ability, and coasting in a straight line.

The Bullnose Rudder is a clamp-on Rudder that fits most electric trolling motors (24 to 55 lb thrust) used for small boats, pontoons, kayaks or canoes. This rudder gives you better control of your watercraft in most weather conditions, eliminating the need for oars. It turns easily when steering and it enables you to drive the craft even while fishing.

It is manufactured from impact plastic for durability and comes with stainless steel screws for fresh water/salt water boating. Hardware for mounting is included along with some mounting tape if your shaft is a bit smaller or if you want it to fit extra tight.

A couple of minutes and a Philips screw driver is all you need to attach the Bullnose Rudder to the shaft of your small watercraft motor. It measures approx. 5″x10″x2″ and clamps onto most 24-55 thrust electric motor shafts. The Bullnose Rudder is a universal design and may be mounted in an upright position on the front or back of the shaft. (Some motors are shorter than others not allowing it to be pointing toward the propeller, thus the “back” mount.) It may also be mounted with the short end down (upside down) for shorter motors. A flexible design to fit your needs.

Clamps fit perfectly on most fiberglass shafts. Use mounting tape provided for aluminum shaft or any smaller diameter shafts.

The Bullnose Rudder is a great accessory for the bass fisherman as well. When the bass fisherman comes across shallow-swampy water and needs to switch to a smaller thrust motor it can be difficult to steer such a large boat. Add the Bullnose Rudder to your 24-55 thrust motor shaft and notice an improvement in your steering.