Description

The LB-AT-8.10.12 L Bracket is built using high quality aluminum alloy, is black powder coated and includes stainless steel hardware. It’s designed to attach a Transducer Shield® to the side of an Atlas 8″, 10″ or 12″ Hydraulic Jack Plate.

Please remember that a transducer cannot be attached to an L Bracket without a Transducer Shield®.

This L Bracket can be used to attach a Transducer Shield to the side of an Atlas 8″, 10″ or 12″ Hydraulic Jack Plate but only if your Transducer Shield® and Atlas Jack Plate size is listed below :

• GARMIN
  • TG-D-Vu on an 8″, 10″ or 12” jack plate
  • TG-GT-6 on a 10″ or 12” jack plate
  • TG-DS-Vu on a 12” jack plate
  • TG-DS-8.4 on a 12” jack plate
• HUMMINBIRD
  • TM-HDsi or TM-DI-2 on an 8″, 10″ or 12” jack plate
  • TM-Csi or TM-DI on an 8″, 10″ or 12” jack plate
  • TM-HX-3 on a 12” jack plate
  • TM-ONIX-1 on a 10″ or 12” jack plate
  • TM-ONIX-2 on a 12” jack plate
• LOWRANCE
  • TS-LSS-1 on a 10″ or 12″ jack plate
  • TS-HDI-3, TS-HDI-4 or TS-DSI on an 8″, 10″ or 12” jack plate
• RAYMARINE
  • TSS-RM-1 or TSS-RM-2 on a 12” jack plate

If the Transducer Shield that you are installing on the side of your jack plate does not appear on the list above, use L Bracket LB-AT-4-Combo for a 4″ Atlas Jack Plate), L Bracket LB-AT-6-R3 for a 6” Atlas Jack Plate or L Bracket LB-AT-8.10.12-R3 for an 8”, 10” or 12” Atlas Jack Plate.

An Extension is required if you have a Skeeter ZX model boat. On this particular boat the hull turning chines interfere with the side viewing signal. To help correct this problem it is necessary to add an extension between the L Bracket and Transducer Shield to lower the transducer.

Please note that when the transducer is attached to a set back, hole shot plate or the side of a jackplate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.