Description

The WG-2.5 wedge is built with black polyethylene marine grade plastic and is designed so that when attached to a Transducer Shield® and attached to a surface, it will put the transducer at the correct angle when the boat is in the water. A transducer CANNOT be attached directly to the wedge and must be paired with the appropriate Transducer Shield® for your transducer.

Use this wedge to install select Humminbird® Side Imaging and Down Imaging transducers or the Lowrance® LSS1 Structure Scan transducer on 90 degree jack plates that have a hole shot plate under the jack plate (for example Atlas and some other T-H Marine jck plates).

The WG-2.5 wedge is used with the following Transducer Shields :

• Humminbird : TM-CSI-2, TM-DI, TM-DI-2, TM-HDSi, TM-ONIX-1 or TM-ONIX-2
• Garmin : TG-D-Vu, TG-DS-VU or TG-GT-6
• Lowrance: TS-LSS-1, TS-HDI-2, TS-HDI-3 and TS-HDI-4

When purchasing this item, please remember to choose one of the following TM or TS model Transducer Shields: Choose LWG-2 wedge for the following Transducer Shields: Humminbird: TM-HDSi Garmin: TG-D-Vu Lowrance: TS-LSS-1, TS-HDI-2, TS-HDI-3 and TS-HDI-4

Please note that the WG-2.5 wedge is not suited to TS-LSS2-L or TS-DSS3-TS Transducer Shield® for the Lowrance® LSS2 10-1/4″ Structure Scan, Total Scan or Structure Scan 3D transducer. Instead use the wedge WG-LSS2 or WG-LSS2-4″. Please call if you need assistance.

Please note that when the transducer is attached to a set back, hole shot plate or the side of a jackplate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.